B7-45°-R7-P6-RA is a mitered door flat insert ¼”panel design with an applied rope and square edges. The rail size is about 2 1/2". The flat panel is made of wood veneer MDF. The thickness of the wood we use is ¾”. The corresponding drawer front for it is F-B7-45°-R7-P6-RA. Please notice the picture you see is meant to help you choose the design of your door, not the color. All our wood doors are raw.

More details

Opening for Glass {{model.openforGlass.name || ""}} {{'(+ $' + (model.openforGlass.price | currency : "" : 2) + ')' || ""}}
Hinge Holes {{model.hingeHoles.name || ""}} {{'(+ $' + (hingeHolesFullPrice | currency : "" : 2) + ')' || ""}}, Bore: {{model.hingeBore}}
You can find more hinge holes typing below:


From top of door to center of hinge. Type 0 where no hole.
Distance {{$index+1}}
11.00" - 96.00"
11.00" - 96.00"
Back Color: {{model.backColors.name || ""}}
Color: {{model.colors.name || ""}}
Note: The colors you see above may not be fully accurate depending on your screen. Those are only to give you a better perception of the object.


Face Type Door
Door Type Miter 45°
Edge B7
Rail 45-R7
Panel P6
Rope Applied

More info

Because wood is susceptible to changes in temperature and humidity joineries to form the face frame can expand and contract exposing visible gaps. Staining and finishing the face frame can enhance this visibility. Lighter colored paint finishes in particular actually accent this gap making it stand out even more. A gap of .010" is acceptable and would not be considered a defect.

Dimensional size tolerances for all Dade Doors Inc products will be +/- 1/16 of an inch.

When wood is exposed to variations in temperature and humidity the moisture content in the wood reflects these changes and its natural response is to grow or shrink in the direction of the grain or slightly twist or bow. Doors up to 24" wide and 44" in height have a warp tolerance of .25". Doors exceeding these dimensions are not warranted against warping. Frames only and recessed panel doors up to 24" wide and 41" in height have a warp tolerance of .25". Doors and frames exceeding these dimensions are not warranted against warping.

Our wood is very clean regarding grain though it is not selected. 

Corresponding drawer front

30 other products in the same category:

Fractions Decimals
1/8 0.125
1/4 0.250
3/8 0.375
1/2 0.500
5/8 0.625
3/4 0.750
7/8 0.875
Fractions Decimals
1/16 0.0625
3/16 0.1875
5/16 0.3125
7/16 0.4375
9/16 0.5625
11/16 0.6875
13/16 0.8125
15/16 0.9375